Sierra Wireless DART 200 CDPD Modem Guia do Utilizador Página 119
- Página / 206
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
DART 200 CDPD Modem User’s Guide 8 Application Programming
PN1197-00 Revision 1.0 8-25
Entries with port numbers can be used as both ping targets and in the
friends’ list. The port numbers are ignored if not required by the
command or function.
Messages and response codes
The DART 200 provides information to the MAS concerning its
operation by response codes and messages. By default (X1) the modem
presents one of 10 response codes in verbose (textual) or terse (numeric)
format. If extended result codes are disabled (X0), only response codes 0
to 4 are available, codes 5 to 10 are mapped onto codes 0 to 4, as
appropriate. Disabling extended response codes is not recommended.
Terse Verbose
0 OK
1 CONNECT
2 RING
3 NO CARRIER - The modem did not have an active CDPD
channel at the time the operation was attempted
4 ERROR
6 NO DIALTONE - The modem was not registered at the time the
operation was attempted
7 BUSY - Connection is busy or an improper port was specified or
the appropriate server was not active at the target location
8 NO ANSWER - Auto answer was not enabled, or that the remote
modem is not registered or has lost RF coverage
9 BLOCKED - PIN Number or Service Provider Key was entered
incorrectly three times, or the Unblocking Key was entered
incorrectly ten times. To clear this condition refer to Appendix F,
Clearing blocked status, p. F-23
10 NOT ENABLED - A command requiring a PIN, or requiring the
modem to be in Service Provider mode was used
Messages
The only standard message that the DART 200 issues is:
INVALID NEI: CONTACT SERVICE PROVIDER
This means that the modem does not have an IP Address (NEI) stored in
it yet, so enter one before starting communications. It does not prevent
the modem from processing AT commands as part of normal modem
setup.
If other messages are encountered, contact modem technical support for
assistance.
??
NOTE:
Error codes 7 and 8 do
not apply to UDP,
because UPD is a
connectionless protocol
with no error feedback.
- DART 200 CDPD Modem 1
- Sierra Wireless, Inc. ii 2
- Important Notice 3
- Contact Information 3
- Safety and Hazards 3
- Sierra Wireless, Inc. iv 4
- Contents 5
- 2 Installation and Setup 2-1 6
- 3 CDPD Security Features 3-1 6
- 6 Device Attachment 6-1 7
- 8 Application Programming 8-1 7
- Sierra Wireless, Inc. viii 8
- PN1197-00 Revision 1.0 ix 9
- H Problem Sheet H-1 10
- Glossary Glossary-1 10
- Index Index-1 10
- Notes Notes-1 10
- PN1197-00 Revision 1.0 xi 11
- Sierra Wireless, Inc. xii 12
- About This Guide 13
- Related reading 15
- Compliances 16
- Safety information 17
- Sierra Wireless, Inc. xviii 18
- 1 Introduction 19
- New for this version 20
- Migration considerations 20
- CDPD network overview 21
- AT command set summary 22
- PN1197-00 Revision 1.0 1-5 23
- Sierra Wireless, Inc. 1-6 24
- 2 Installation and Setup 25
- Sierra Wireless, Inc. 2-2 26
- Getting started 29
- Basic modem personalization 30
- command, for 31
- AT&W 31
- command to check that 31
- Initial testing 32
- Sierra Wireless, Inc. 2-10 34
- Problem determination 36
- Sierra Wireless, Inc. 2-14 38
- Sierra Wireless, Inc. 2-18 42
- ENTER, the cursor returns 43
- Sierra Wireless, Inc. 2-20 44
- Basic communications 45
- Sierra Wireless, Inc. 2-22 46
- 3 CDPD Security Features 47
- Modem security management 48
- Sierra Wireless, Inc. 3-4 50
- 4 Broadcast and Multicast 51
- Operation 51
- Broadcast 52
- Multicast 52
- Multicast setup 53
- Sierra Wireless, Inc. 4-4 54
- 5 DART Supported Protocols 55
- Sierra Wireless, Inc. 5-2 56
- PN1197-00 Revision 1.0 5-3 57
- for UDP 59
- Sierra Wireless, Inc. 5-8 62
- How the UDP behaves 63
- Sample UDP server setups 65
- DART TCP capabilities 68
- Friends Only mode operation 68
- TCP communication 69
- Setup options 71
- *A (select server type) AT 71
- for TCP 72
- Sample TCP setups 73
- SLIP IP Address overview 78
- Class NEI SLIP Address 79
- provided it is not 81
- Telnet escape commands 84
- Sierra Wireless, Inc. 5-32 86
- 6 Device Attachment 87
- Sierra Wireless, Inc. 6-2 88
- Computer 88
- Terminal 88
- PN1197-00 Revision 1.0 6-3 89
- Sierra Wireless, Inc. 6-4 90
- 7 Vehicle Installation 91
- Considerations 91
- Proximity to other antennas 92
- PN1197-00 Revision 1.0 7-3 93
- Sierra Wireless, Inc. 7-4 94
- 8 Application Programming 95
- Application program structure 96
- Data transfer 97
- Modes of operation 97
- Error recovery 98
- &S0 (always active) 98
- Automatic registration 100
- Registration timer 101
- Manual registration 101
- Auto-Registration at power-on 101
- Data forwarding 102
- PN1197-00 Revision 1.0 8-9 103
- Sierra Wireless, Inc. 8-10 104
- Auto answer setup 105
- Flow control considerations 106
- PN1197-00 Revision 1.0 8-13 107
- PAD operating mode 108
- Data and control interface 109
- Binary data transfer 110
- Parity considerations 111
- PAD keep-alive considerations 112
- PN1197-00 Revision 1.0 8-19 113
- Command response options 114
- Echo option selection 115
- Baud considerations 116
- PN1197-00 Revision 1.0 8-23 117
- Modem dial directory 118
- Messages and response codes 119
- Sierra Wireless, Inc. 8-26 120
- A Limited Warranty and 121
- Sierra Wireless, Inc. A-28 122
- B Product Specifications 123
- Sierra Wireless, Inc. B-2 124
- C Charts and Diagrams 125
- Sierra Wireless, Inc. C-2 126
- D SLIP Setup Examples 127
- Sierra Wireless, Inc. D-2 128
- Windows 95 129
- Sierra Wireless, Inc. D-4 130
- E S-Registers 131
- Sierra Wireless, Inc. E-2 132
- Register definitions 133
- PN1197-00 Revision 1.0 E-5 135
- • Value Baud: 135
- • Stop Bits: 135
- • Data Bits: 135
- PN1197-00 Revision 1.0 E-9 139
- Sierra Wireless, Inc. E-10 140
- PN1197-00 Revision 1.0 E-11 141
- PN1197-00 Revision 1.0 E-13 143
- Sierra Wireless, Inc. E-14 144
- F DART AT Command Set 145
- A/ Repeat 146
- A Answer Online 146
- D (cont.) 147
- E Command Mode Echo 149
- F Online Mode Echo 149
- H Hang-up (close connection) 149
- I Identify 149
- Q Quiet Mode 150
- V Verbose Result Codes 151
- Z Soft Reset 152
- &C Set DCD Operation 153
- &D Set DTR Operation 153
- &S Set DSR Operation 155
- &W Save Active Profile 156
- \J Restrict Channel Selection 157
- \J (cont.) 158
- \M Manual Transmit Control 158
- \N Set Side Preference 158
- \Q Set Flow Control Operation 160
- \S Set Subscriber Identity 161
- \T Automatic Transmit Control 162
- *A Select Server Type 162
- *K TCP PAD Keep-Alive 164
- *L Set Listen Port 165
- *P Ping Remote Host 166
- *R Automatic SLIP Mode 166
- *T Telnet Keep- Alive 167
- Service provider commands 168
- PN1197-00 Revision 1.0 F-25 169
- ^F Force PIN Usage 171
- ^S Set DART SLIP Address 173
- -L Lock on a Specific Channel 174
- G Loading DART 200 177
- Firmware 177
- Sierra Wireless, Inc. G-2 178
- H Problem Sheet 179
- Sierra Wireless, Inc. H-2 180
- Glossary 181
- A (cont.) 193
- C (cont.) 195
- M (cont.) 198
- S (cont.) 199
- T (cont.) 200
- W, X, Y, Z 201
- PN1197-00 Revision 1.0 203
Manuais e produtos relacionados com Redes Sierra Wireless DART 200 CDPD Modem
(20 páginas)
Redes Sierra Wireless RJ-11 Manual do Utilizador
(1 páginas)
(1 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.091 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais